Author: Andrew March 20, 2015

I like being prepared in advance as much as possible.  So after reading BYO’s version of canning yeast starters, I made adjustments for me and actually thought out the process.

Gather Supplies

You will need:

• 1 Pound DME
• Some hops (possibly optional)
• Five 1-Quart Mason jars, bands, and lids
• Pot for boiling wort
• Large stockpot for sanitizing jars
• Pressure Canner (you can probably safely do this in a boiling-water bath canner, but wort isn’t really acidic enough to be safe for this)
• Something to stir the wort with
• Old dishtowels
• Clean washcloth
• Canning tools (see below)

 

Process

1. Start bringing 5 quarts of water to a boil
2. Fill large stockpot to 1″ above top of Mason Jars, set on heat and heat to 180F/82C
3. Wash Mason jars, lids, and bands – put jars and lids in stockpot carefully
4. When 5 quarts of water is boiling (or even near-boiling), shut heat off, add 1 lb DME (preferably light or very light) and hops, stir well, and turn heat back on
5. Boil wort for 10 min
6. With a few minutes remaining, prepare jars – remove them from the water, drain, and set on a towel near the wort pot
7. Once the jars are out of the stock pot, remove it from the heat, and ladle some of the hot water into the pressure canner
8. Once the wort boil completes, shut the heat off and fill the jars to 1/2″ headspace
9. Wipe the rim of the jars, and cap (do not torque the rings down!) and add to pressure canner
10. Once all 5 jars are in the canner, put the lid on and begin a boil
11. Let steam vent from the canner for 10 minutes (see the pressure canner instruction manual)
12. Add weight and process for 30 minutes at the correct PSI (for my area east of Cincy, the appropriate pressure is 11 PSI)
13. At the end of the process, shut the heat off, but leave the weight in place (or otherwise leave the vent in place – you do not want the pressure to drop too rapidly or the jars can crack or burst
14. Once the pressure has returned to 0 on the dial, remove the weight and wait 10 minutes
15. After the 10 minutes, remove the lid and jars, place them on a towel (do not put them directly on a cold countertop)
16. Once the jars cool, confirm that they are properly sealed (the lids should be “sucked in” and not click when pressed), and store in a cool dark place away from any source of UV light

Using the Starter

Using this is pretty easy.  Remove the ring and spray the lid area with sanitizer, and then pour into a sanitized flask.  Then, pitch yeast, add a stir bar, and put on a stirplate.  The 1 Qt jars are roughly 1,000 mL of yeast starter.  Depending on your yeast and situation, you may need to use multiple jars of starter.

Cheers!